• The Miniature Circulation Heater is a packaged heater for heating small volumes
  of liquids as in photographic developer solutions, chemicals, dyes, and inks.
• Constructed of 316 series stainless steel.
• Pressures to 100 psig.

1. Heliarc weld.
2. Stainless steel sheath.
3. Liquid turbulator wire.
4. Ground Post.
5. Post terminals
6. Connection box. 2 3/4″ x 1 1/2″ x 1 1/2″.

Red catalog number denotes stock item. See stock section for specific ratings.

Above wattages are based on 50 watts per square inch for use with water at low flow.Higher flow rates and/or different liquids will effect allowable watt densities. Consult factory.

Sizes between those listed and larger in diameter are available. Consult factory.

Thermocouple mounting fitting is available for use with the standard miniature circulation heater.The fitting is threaded into the exit end as shown below. Specify TC-5 fitting.

* Thermistor adapter and catalog number TH-1 must be used for thermistor probe mounting in the TC5 fitting.

SPECIAL IMMERSION

• Restaurant Steam Tables
• Humidifiers
• Water Tanks
• Food Cookers
• Process Water Heaters

• All stainless steel (316 L) with heliarc welds – No copper or braze material in contact with water.
• Patented – Low water protected – Automatic of internal high limit – Shuts off heater, then resets itself.
• Flexible hook-up leads for wire nuts.
• Easy to clean.
• Easy mounting through a 2 7/16″ diameter (2″ knockout) hole in bottom or side of tank – No need for mounting fittings.
• Other sizes and ratings available – Consult factory.

Specify Catalog Number from table above.